@pindac, it is another lesson that mass alone does not work. Certain materials are more prone to ringing, some are intrinsically better damped. Examples of the later are aluminum and most wood over a certain thickness. Panzerholtz is resin infused plywood. The layers have been dyed for aesthetic reasons. It makes great plinths and could even be used as a sub chassis in a suspended design. My turntable used a 1" thick aluminum sub chassis. I doubt it would sound any different if it were made out of panzerholtz.
Origin designs are fine. Unfortunately, the company has a reputation for bad service. It has come up on this site several times.
@musicmatters1206 , No, it will not be fun. You will wind up listening to the one you like best and the other will just take up space and money. Put that money into a better turntable and cartridge The very best value in a less expensive table is the Thorens TD1600 followed by the RP10 and then on to the Sotas. If you want the ability to upgrade down the line Sota is an even better choice. The only time you need a second cartridge is to play 78's. As often as you would play them swapping out the cartridge would be the most efficient way of going about it.
Manufacturing turntables and tonearms is not all that difficult. I have seen several very reasonable home spun units. Making them with intelligent design and aerospace precision is not so easy. This leads to an unfortunate number of enterprises that make rather poor gear. Any company that makes a unipivot arm is suspect. Some, like Clearaudio and Kuzma do it at the low end of their ranges to keep the price down. Some do it because it is child's play to make them. Graham and Basis arms are no longer unipivots they are bipivots. Outboard motors are another point of contention. Turntables with more than one platter are functionally a joke. More bearings equal more noise.