JL Audio CR-1 Crossover

gita,

Never thought about an intergrated amp with the CR-1. Seems like there should be a way to make it work.

ozzy

Ozzy, I could put it in front of my Cary sli-80, but that would accommodate only one input; either my cd player or my 'table.

Or I could first put my two sources into a passive preamp, then that pre into the CR-1, then split into the Cary and the subs.

It gets complicated and adds more to the signal path. Discouraging.

Anyway, I don't mean to rain on your parade. Enjoy!

I replaced a pair of RELs (using high level input from the amp) with a pair of fathoms with a CR1. This was to correct a 60Hz room mode on the vertical axis generated by the main speakers.  There are measurements pics of this on my system page. The CR1 has a button to switch on/off the crossover circuitry, so A/B is easy. In my case bass extension is a little less and the blurriness around 60Hz reappears with the subs and crossover circuity off. The promise of decreased upper frequency distortion was not materialized in my case, although the coherence between the woofer and the "midrange/tweeter" improved. I have just used factory settings at 80Hz which seems like an obvious choice based on my problem. Playing the damping only made it wound worse. I am still experiemnting with placement/DARO a little bit as well as phase. It seems damping would be normal last step. As a side I find DARO pretty havey handed through its band, making "good enough" placement idiot proof. I am still working through it, though.  

gita, Perhaps contact JL Audio for suggestions?

ohlala, If this helps:

I started with my subs close to the back corners, then I used the DARO. After that I tried to blend their output with my main speakers. Then I used the CR-1 to blend everything together.

But, I too am still experimenting with all the other settings. I can say though that just 2 days with the CR-1 and I am pretty happy with the bass intergration.

BTW, I also have 4-ASC 20" tube traps in all 4 corners.

ozzy

I had help from acoustic frontiers in sub/speaker relocation to smooth out bass. I have at least a hundred REW measurement from this misadventure. The subs ended up near opposite corners of the room, which flattened all but the 60Hz. Elevating them half way up the wall helped partially, and the crossover eliminated it. With the fathoms, I now have a 20 Hz issue, below what DARO controls. I pulled one sub out in the room as far as resonable to flatten it, but created a massive 34Hz issue that daro amazingly corrected. I did waterfall overlay between the two radically different positions, and there was not much difference even in decay time. I could not really hear a difference either. I may try moving one sub to the corner, so the pair are symmetric to see what happens. 

Like you suggest, I also EQ’d it then adjusted levels, which is easy. The LF trim control’s bandwidth is too broad, so of course volume has to be adjusted. Unfortunately I do not know how to use stereo with separate phase controls and use DARO at the same time. Are you using master/salve configuration?