Thank you all for your input. I am getting a better idea of the what I need and do not need to consider in my decision making process. I am running a Musica Pristina A Cappella III connected via I2S to Denafrips Pontus that is connected to W4S STI1000 V2 using XLRs to Cornwall IVs. In this set-up I also rotate in a Fisher 500C that is connected to Pontus with hybrid XLR-RCA cable. The components are located on a rack between the speakers that are approximately 8-9 feet apart. I'd like to transition to a Decware mono set-up with a true balanced pre-amp (TBD/suggestions?) where I can locate the monos next to the speakers and move the rack to a side wall. Moving components to a side wall will necessitate a run of approximately 12' to for right channel mono and 18' to left channel mono. That is why I am inquiring into balanced vs XLR and balanced vs unbalance. Any suggestions for an preamp ($3K ballpark) that would work with this set-up or any other thoughts on this set-up are appreciated.
RCA vs XLR and Balanced vs Unbalanced
Newbee needs some help understanding the benefits (if any) of using RCA vs XLR connections and using a balanced vs unbalanced components. What are the benefits of using balanced components (DAC > pre-amp > amp)? Does balanced sound better for some reason? It is my understanding that to take advantage of a balanced system, you need to use XLR cables. Correct? RCA cables will negate the benefits of a balanced system? For example, if I have a set of cables that are terminated with XLRs on the DAC end and RCAs on the pre-amp end. If I have a balanced DAC should I be using a balanced pre-amp? A balanced amp? As my line of questioning indicates, I have no understanding of how a balanced system works and why it is preferable to a non-balanced system. Any guidance will be greatly appreciated. Cheers.
- ...
- 13 posts total
As already answered above home distances are nowhere near long enough to justify XLR. I will go out on a limb right now and say all the info you will get on this will focus on technical jargon and totally miss the big picture. Which is, as also previously stated, quality matters in audio more than anything else. You can spend a fortune on high end components and then ruin it all by using long runs that cause you to cheap out on wire. Quality wire is so much more important than any technical considerations, but you can flail and flounder many years and never figure this out. It happens. I have seen it. If you are forced by the layout of your living arrangements and traffic flow that is one thing. But if you are using long runs hoping to gain more in having things off to the side, forget it. Not happening. You will cheap out on wire, and this will cost you ten times what you hope to gain. XLR vs RCA does not even factor into it. |
@bgchz, before you decide where to locate your components, buy and read Jim Smith’s “Get Better Sound”. He has a section on this topic. Jim Smith’s profession is setting up and consulting on residential and commercial high end audio rooms and recording studios. He’s received several best-sound-of-show awards. Check it out. |
- 13 posts total