Build-up on stylus - any new cures?


Hi, I run a restored TD-124 and SME 3009 series II, a Shure V-15 III, and a JICO SAS stylus. The last record or two I played sounded a bit off and I wondered whether I had managed to wear out the stylus. Using a pocket microscope I bought for this, I was able to see that the stylus tip still has good "shoulders," so that much is good. However, it has an astonishing amount of sparkly white build-up around the diamond.

There is a thread on here from 2014 with good advice, and I've used slices from a magic eraser for some years now, occasionally with alcohol. Usually I clean the stylus every other record side with a dry ME. Any new thoughts on removing this junk?
One 2014 poster suggested gently dragging the stylus on the ME back to front. I have never done that but would like to hear if anyone thinks that is safe for the tip? Hopefully there is an inexpensive solution, thanks!
mixermarkwilliams
mixermarkwilliams
... For the various people that assumed that I don’t clean my records, I actually never play one I haven’t cleaned unless I cut the shrink wrap right beforehand. And sometimes I clean even new records first. The cantilever tip around the diamond looks like a snowball with just the tip of the diamond peaking through ...
Assuming your stylus isn’t damaged and your setup is ok, your records can’t possibly be properly cleaned if you end up with that gunk on your stylus. Even new records often have substantial dust (or worse) on them and require cleaning.
@mixermarkwillams 
Is the snowball that you reference with the needle peaking thru possibly the adhesive that is used to attach the needle to the cantilever?
My cartridge looks like that also and it’s the adhesive holding the needle in place. I’ll put my cartridge under a microscope later to re-verify that is what it is.
Thanks, but no, it is clearly a buildup of some sort. The 2014 thread about this noted that vinyl shed from records looks like this and consists of short rods in shape.

My listening tastes are not very mainstream. Some of the pressings I listen to are musically on the fringe in various directions and sometimes not the best pressings.

Some also are from the mid-late 1970s when the oil embargo led to high percentages of recycled vinyl from returned or scrapped records. At first some of those pressings not only blended crunched up vinyl from random sources, but sometimes included bits of label from the scrapped pressings. A machine was created to punch out the center of scrapped records to avoid pollution in the slurry from bits of old labels, but it was not a good time for vinyl quality in independent pressings. This deposit on my cantilever could have come from a particular disc that I hope to identify at some point.
mixermarkwilliams
This deposit on my cantilever could have come from a particular disc that I hope to identify at some point.
Most likely it was accumulation over time from multiple records. What are you using to clean your LPs?
A combination of LP9 or alcohol in conjunction with dipping in Magic Eraser should take care of the problem