Turntable Power Cord Upgrade

I would be interested what people hear with different cords. I tried 2 cables on my ref 2 power supply. Can’t tell a difference over the stock cord.

Hello,
One reason for an upgraded power cord is RFI filtration. Most of us have our cords coming close or crossing other cords including speaker and other interconnects. Also, 
Even though I have not tested it there might be something to the consistency of the speed. If you have a TT that governs the speed perfectly then it’s good to go. Last but not least is that most of us have an extra less expensive but good cable lying around. Those basic cables are very cheep. What if you move your power strip or conditioner and the power cable ends break off or short. It’s like owning a nice car and putting really bad lawn mower can gas it it. Not recommended. 

Turntable power cord upgrade?  Really?

LMAO

My first turntable mod years ago was to separate the power cord from the RCA outputs on a Technics belt drive table from the 70’s- cost little, sounded quieter, cost 30- 45 min & some solder.
On that table they ran really close together- design less than optimal. 

I fitted a Furutech IEC to my Technics CH10E (PS for Technics SP-10 Mk2a) for the sole purpose to find out for myself if an upgraded PC would have any sonic improvements to the sound. Nordost V1 PC vs. $10.00 PC were used for comparison and I didn't heard any difference. This is NOT to say other TT manufacture's PS will yield the same results. Just not with the SP-10 Mk2a.