Audio envy - dang!


I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC. 

I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.

I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s

Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.

The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”

And that’s just what I did.
last_lemming
Per my correspondence with Cap last week the Mega 3 is basically two Ocean Elite 3's put together and is mainly for power conditioners.  So pricing is two sets of wire and one set of connectors. 
Mega 3 (6 conductors, two ocean elite in a twisted geometry) is recommended for any component that’s drawing more current, i.e. power conditioners, Integrated, amps and subs. And use Ocean Elite 3p or 2p for source components including preamp. That’s how my system is currently wired :-)