In my experience Clearaudio cartridges have always been right on the money. I have owned and examined 4 of them. One of them was the one that lost it's diamond which was covered under warranty. The one Soundsmith I have is right on the money. The AT VM75ML that I put on the Sota when I sold it was not so good. It's SRA was about 89 degrees. I had to lift the back of the arm up quite a bit to compensate. Azimuth and zenith were fine. The Grado Statement that I used for years also had the SRA off by 2 degrees as well as the azimuth being off a degree or so requiring me to tilt the cartridge a bit.
Wally Tools to Offer a New Service.
They have not said how much they are going to charge for this new service yet but if you do not have your own microscope it would be of significant value and greatly assist in the set up of your cartridge.
A "new" parameter is discussed which they are calling "zenith." I have always called it "twist" but I suppose zenith sounds more....important.
Read all about it here, https://www.analogplanet.com/content/zenith-angle-correction-final-set-frontier
A "new" parameter is discussed which they are calling "zenith." I have always called it "twist" but I suppose zenith sounds more....important.
Read all about it here, https://www.analogplanet.com/content/zenith-angle-correction-final-set-frontier
- ...
- 15 posts total
- 15 posts total