I just had installers run speaker wires in wall (dry wall was taken off for remodel) to both surround back left and right. Also my left front speaker wire is run in wall to the left front of the room. I now have 3 speaker wires terminating where my amps will be. Other than connecting each wire to the output of my amp, turning on the amp with source (which would require essentially setting up my system) and then seeing which speakers get signal, is there a tool that can test which termination wires go to which speaker?
^^^That is a Tone Generator which requires a transmitter & receiver,YES works great BUT more $,more batteries,less usefulness compared to a Multi Meter...
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.