1. Home
  2. amps-preamps
  3. 156443-141476

best budget amp/preamp for B&W 805 D3s

you kind people helped me along the way. here is another question. I am happy with my setup but can’t help but think forward. Have an old Rotel RA 1070 that now powers my new 805s. I use, per your suggestion, DAC (Shiit Modi) to stream Tidal from my Mac. Sound is great but gets a bit choked up (crowded?) when the volume is turned up loud. my question: I have only $1k budget for a new integrated amp. 1) In that budget is there a significantly better amp or amp/preamp combo? 2) Should I wait until I have more $$$ to buy? 3) what budget integrated amps (amp/prem) go well with 805s (other than Rotels)? 
I don’t mind getting used equipment. Please, give me suggestions also for budget amp/preamp combos.
I very much appreciate your willingness to help. I am new at this and not an engineer.
petar3
soix
11,233 posts
 
What sound characteristics are most important to you?
petar3 OP
69 posts
 
many thanks to everyone who responded. i don't normally talk about sound. perhaps, clarity and detail. i listen to new classical music, jazz, some world stuff.

soix
11,233 posts
 
There’s a NuPrime IDA-16 available here now for $1195, and if you’re after clarity and detail — along with a lot of other positive attributes — you should be very happy.  And 200Wpc should help your 805s wake up and get rid of any congestion at higher volume levels. It’s also got a very good internal DAC that may well be better than your Modi, and if so you can sell it and offset some of the cost. If I was you I’d jump on this ASAP.
rockeymarkb
15 posts
 
I do not know how you will get a quality integrated for $1000 which will nicely drive your B & Ws.  B & Ws require quality amplification and are finicky with electronics to boot.  A budget expansion is required in my opinion.  Good luck!
westcoastaudiophile
819 posts
 
For quality sound, B&Ws need to be driven by very low output impedance (aka high damping factor), and high max output current amplifier (> 50A), which rarely can be found in integrates ($$). Less costly option could be an appropriate Power Amp, and then finding better preamp. Class A, with minimal load of 2 Ohms is a good start to look for amp4bws. It could be A-70 Accuphase, or Pass alike. 
More to discover