Help in minimizing hiss


I’m wondering if all hiss can be removed, particularly with highly efficient speakers.
The hiss in my system is audible from about 4-5’ away when it’s silent in the house.

All gear is on a dedicated line I installed with new 12/3 romex to the panel with a 20 amp breaker.
I’m using all quality power cables and XLRs.

Rig:
Oppo 105 - Schitt Freya + - Legacy Wavelet DSP - Pass Labs X260.8 - Legacy Valor (101 dB sens)

Thanks for any input you may have,Scott
simpleman68
I doubt that new tubes will help, but give it a try. You can do much better than the Freya but you will most likely have to spend more money. In my experience your cables will not help this problem one bit.
You should work with a reputable dealer and request low-noise and low microphonic matched tubes. The quality and noise level of a 6SN7 can vary greatly, but the right tube will provide wonderful sonics in a preamp.

I mentioned a power conditioner for your sources since noise from the AC line will also be audible thru your speakers. This is not hiss, but every line connected to the power grid will introduce noise into the system (even a dedicated line). 

@erik_squires  I do have absorptive panels covering much of the wall behind the speakers and a 2'X4' treatment on sidewalls at first reflection points. Room is 18'X 34' with 19' ceilings.
@jsautter I'm only rolling tubes to replace the JJs that came with the Freya.
@lowrider57  Tube Depot set me up with low microphonic, matched etc GE 6SN7 GTAs. Should be here in a few days.
Turned on the Pass amps first and there was almost no audible noise with my ear on the tweets
Then I turned on the Wavelet and the hiss came back but not full volume
Then the Freya in full tube mode and the hiss got a bit louder but not much
Approximation:The Pass amps are less than 10% of the hissThe Wavelet is about 60% of itThe Freya (surprisingly) is only about 30% of the hiss
Thanks again for all the help guys, it's greatly appreciated.I can live with a bit of hiss that is inaudible from 3' + but just want to be sure I'm doing all I can to keep the signal path clean/clear.Scott
Let us know how the tubes help, but my fear is that these old stock GEs will increase the noise and you may find new noises which didnt exist before. Hope I am wrong.