2. misc-audio
  3. 151896-65954

15 amps vs 20 amps

Firstly, let me state that I’m no electrician so forgive my ignorance about all this....

My wife and I have just moved to a new house.  We’re very happy, but there’s something unusual about the house! The great news is that it’s almost completely Ethernet wired and came with a kick-ass networking system. Fabulous wireless and Ethernet performance everywhere.

After a few days unboxing and settling in, I thought I’d rig up my system.  This is where the apologies start - I hadn’t actually noticed that most of the house is supplied by a 20 amp circuit, until I tried plugging in my Audioquest Storm power cable, which is meant to connect to my15amp Niagara power supply, and then to my components. No harm done, but the plug was clearly not fitting easily into the outlet. I didn’t force it and stopped  my installation. 
It looks like setting up my system is going to be a project.  Firstly, can anyone tell me if it’s ok using 15 amp audio components through 20 amp outlets? Do I need to change anything like fuses, plugs, outlets? Will 20 amps be good/bad/same for performance? Safety concerns?

As you can tell, I know very little about this and would prefer not to make a costly mistake.

thanks for any advice.




janehamble
millercarbon's avatar
millercarbon
12,531 posts
 
Amps is a measure of current flow or volume. Voltage is analogous to pressure. Your 20A circuits are capable of supplying more current than your 15A components will draw. Think of this as excess supply. This is a good thing.

If you had 240 volts, with 120v components, that would be another story because voltage is pressure, then you would have a problem. As it is you have no problem whatsoever.
erik_squires
15,886 posts
 
Hello.

20 Amp circuits are often used in homes with 15A components/outlets. Perfectly "legal." The idea is that you can therefore run more components on one circuit.

Imagine you have 4 x 5A devices. A 20A circuit will let you run all of them at once.

However, if you do in fact have a 20A circuit, with a 20/15A plug (has one pin shaped like a T) you can run higher wattage power conditioners.

Not much of a gain in my mind, but there you go.
Best,
E
builder3
753 posts
 
Your home is actually wired better than most average homes today. Not only is it not an issue, but consider it an upgrade.
This is assuming that those 20A circuits are actually wired with 12 gauge wire. Contrary to what Erik says above, it’s a definite step up. Most homes today use 14 gauge wire and 15 amp breakers everywhere that they can, it’s cheaper. There are a few dedicated circuits that are required by code to be 20A, and all of the lighting, and most of the outlets are usually 15A.
Your plugs should fit in the outlets fine. If they're 20A outlets, they're stiffer.
If anything you see concerns you, call an electrician to have a look, you’ll be out the cost of a service call.


More to discover