Yamaha GT 2000 vs new SL Need advice.


I've done a lot of research and listening. Normally I wouldn't have any doubts but my favorite vintage table is so rare here in the US I haven't been able to hear it.  The reading I've been doing for what I hope will be my last turntable purchase has convinced me that the choice is between the GT and the new SL. 

Is that crazy?  Is a fully serviced GT as good or better than a new SL 1200 G or is the new technology on the SL the winner?


mannye
Based on specifications only, these are two very comparable turntables, both with coreless motors that I prefer.

In my opinion, if you have your GT2000 fully restored electronically and then calibrated by one of the rare breed that can do it right, you would be on the same footing with a new SL, and perhaps a few thousand dollars richer for not having purchased a new SL.  One would have to do a careful A/B comparison after that, to choose one over the other.  (I am not qualified to choose one over the other, as I have never heard either.) One person who can do the work for you is JP Jones of Fidelis Analog in NYC. I advise you to contact him.
Question I have is if your looking for that last table why not invest in a newer design that will last longer if they are that similar. I've not heard either table but for the dollars I'm sure there is other out there  you should consider. That said I did also go vintage from a modern design and am listening to more music then I did with the $7000 oracle. I went the garrard 301 route but there is others. 
The GT2000 has already lasted ~30 years. Why would it not last another 30 years with proper care and use? Perhaps the bearing will need attention eventually, if it doesn’t already need it, but otherwise....
I do advocate going through the GT2000 thoroughly from the outset, with new electrolytic capacitors, possibly upgrading transistors, calibration of the drive system, attention to the bearing, etc. I am only guessing that this would still be way cheaper than purchasing a new SL. The great revelation of this thread is that in fact we are NOT living dangerously with vintage direct-drive turntables.

The OP’s question is about choosing between one DD and another DD, whereas you made a paradigm shift by going from a suspended belt-drive to a non-suspended idler-drive. Good choice, by the way.

EDIT. In my remark about not living dangerously, I was thinking of the other thread on direct drive, the "living dangerously" thread. Sorry.
Thanks everyone.  I loved the reference to the other "dangerous" thread which has over 1000 responses! wow.   

As far as other types, I have right now a Music Hall MMF-5 with the Goldring 1012GX mm cart that sounds very nice and a Sony PS-X5 which is still going strong after 40 years.  The Music Hall has the advantage over the Sony but I am pretty sure that's the Goldring kicking the ass of the  Shure M97xE on the Sony and not the turntables.  

I swapped the carts before when there was an even cheaper AT cart on the Sony and there was no contest between the two.  I'm curious if the arm on the Music Hall would like the Shure...  but I digress... 

I think the GT 2000 is the way to go.  At the current time, and at least for the next several years either turntable (GT or SL)  would be the highest fidelity component in the chain.  

The rest of my 2-channel system is vintage Yamaha (CR 2020 and NS 690ii speakers) The receiver will be going out for a total restoration by a Yamaha specialist soon and the speakers have already been worked on by the previous owner.  

The most that will happen is that the 690ii speakers will be replaced by a pair of NS 1000 once I get my hands on a pair.  
Is the new Technics SL1200G in the same league or better than the SP10 Mk2 ? Normally the GT-2000 is pitched against the SP10.