Grado Statement series carts


I've always wondered about these and I'm just hoping someone can share how you set up your phono stage or SUT you use and what brand you like for your Grado. They aren't the standard mi/mm and have a mc like output of .5mv but with a standard mi/mm input capacitance of 47kilo ohms. Thank you. 

128x128fourwnds
Hi Yogiboy,

It’s not possible to define a simple "yes" or "no" answer to your question, as there are many equipment-dependent variables that are involved.

Phono stage gain of 47 db is a little bit on the high side for most high output cartridges, and significantly on the low side for most low output cartridges. It might be just about right for some Grados that are spec’d in between, at 1 mv.

With a higher output cartridge (e.g., one rated at say 4 or 5 mv or more) a risk would be that in combination with the relatively high 18 db gain of your line stage you might be forced to use your volume control at undesirably low settings, depending on the gain of the power amp and the sensitivity of the speakers, and on the characteristics of the volume control mechanism. Or, if the design of the line stage is such that active circuitry is "ahead" of its volume control in its internal signal path, depending on the line stage’s maximum input spec it might be overloaded on the high volume peaks of some recordings. Or there might be some cases in which the phono stage itself may be overloaded by a cartridge having particularly high output, on the high volume peaks of some recordings.

But it’s entirely possible, and perhaps probable, that none of those risks would materialize in many cases.

With a low output cartridge one risk would be that to achieve satisfactory volume on some recordings you might find yourself wanting to turn the volume control higher than its max setting, depending on the gain of the power amp and the sensitivity of the speakers. And depending on the sensitivity of the power amp you may not be able to turn the volume control high enough to utilize a good deal of the amp’s power capability, should you want to do so. Although the relatively high 18 db gain of your line stage works in the direction of minimizing those risks, unless the cartridge has an especially low output (e.g., significantly less than say 0.5 mv). Another risk, though, that is perhaps more significant, is that a phono stage designed to provide 47 db of gain may not be designed to provide noise performance that is good enough to be suitable for use with many low output cartridges.

So as I say the answer to your question is complex, and involves many variables that are specific to each system.

Regards,
-- Al

Thanks guys. Super helpful. I've always wondered about the sut's with Grado s. Yogi your question is also one I've been asking myself. 

Hi AL,
Thanks for the information! My problem is too much gain with a 1.5 mv output Grado.To lower the gain I replaced the 12AX7 tube with a 12AT7 and it seems to do the trick.
Yogiboy
Yogi, that is interesting, after talking with Mike S. I got the impression that gain in the phono (still running the Quickie?)was there to provide homc's enough gain. He mentioned one in particular that he liked very much. I don't see a system posted on your profile what is the rest of your rig. It seems like with your set up a .5mv statement series would be right in there synergistically. 
Hi fourwinds,
I use the 1.5 mv Grado Sonata and TLZ ( vpi version). I use the new Quicksiver phono with  a Quicksilver linestage and Quicksilver amps. I replaced the 12ax7 gain tube with a 12at7 and the gain is lower like I like it. The new Grado statement V2 has a 1 mv output. I like the volume control at the upper end. Thanks for the reminder,I will post my system.Yogi