Best Speaker to use with Arcam AVR300?

Hello All, I haven't had any responses to my last question. I'm afraid I have burned everyone out on this topic. Please know that I greatly appreciate all you of comments and suggestions. It was very helpful in my decision making process and I learned a few things also. Thank you.

Denon, just so you know I'm not burned out, :-) but I don't have any experience with Triangle products. I suggest opening a new thread for opinions on the Titus 202. Good luck.

Thanks Friz, I took your advise. See my new thread. :)

Really!...what's the room, budget, etc?
Still, with ANY RECEIVER, you're looking at limited power output compared to separates. My first choice for you is the Triangle's! yes, they use a simple crossover, thus have better control over drivers, and more like an active speaker, for better dynamics with your receiver. They also sound good from what I hear(no pun)
STill, I see you bought the receiver first! Many do this, and fall in love with a receiver. I don't. Speakers are FAR MORE IMPORTANT to the sound of the system, followed by amp and source, then wires, etc. The room being equal to all of these together.
STill, I'd have got the speakers, then the amp/receiver whatever. But there you are.
That said, the Arcams a clean reiver indeed. Cross speakers over to small, use a sub for sure, and go with more efficient higher sensitivity designs thusly.
Look into the Triangle Titus, celius,etc.
Good luck

I use Epos M15.2s for L&R, M8 center and M5s for L&R surrounds. Bottom is produced by an original ACI Titan II subwoofer. I use an Arcam AVR200 for driving them. The Epos work very well with this reciever: a warm, yet detailed sound that to my ear have great tonal accuracy. If I had the 300 I would use the back channels to drive the 15s.