2. tech-talk
  3. 1078811775

PS Audio 500 questions

I received a PS Audio 500 today that I purchased on Audiogon. I plugged a tube preamp and a tube phono preamp into the TWave setup sockets and plugged my CD and Turntable into the ultimate outlet sockets on the back. The output voltage was first set to 117V and the to 115V. The power usage display runs about 50% as it should, but after a few minutes the display binks HOT and the regneration outlets shut down. Did I purchase a bad unit or is there something I don't understand?
Jeff
128x128jwin
ipy
113 posts
 
This seems to be a common problem with some of the earlier P500s. I had a demo unit once from a dealer and it had the same problem. More than likely the fan is not working or the card that controls the fan is faulty. Contact PS Audio. They should be able to help and they are very customer focus.
Good luck........
warrenh's avatar
warrenh
2,299 posts
 
Wouldn't calling PS Audio be the way to go? They, I would think, would know in a flash what the scoop is.
jwin's avatar
jwin OP
101 posts
 
Ipy,
I pulled the cover and applied power. Sure enough the fan was not operating. I then plugged the unit back into the system at the 50% consumption to check if there was a load trigger and still no fan. I'll call them this morning because I can't see anything obvious like a disconnected plug.
Thanks,
Jeff
More to discover