Fast/Slow fuse?


I was looking for two kinds of fuses, one slow blow (10A, 250V) and one fast blow (4mA (?), 250V). Went to RadioShack and found that they had fast blow type fuse for 10A/250V and slow blow type for the other.
I just bought them anyway.
What would be the worst possible problem of using fast blow fuse instead of slow blow fuse, and vice versa?
128x128ihcho
JEA48 is correct about the inrush current. Some manufacturers insist on blasting the current in, and the risk of blowing fuses is far greater. A good 30-45 second bleed of power in the circuit is far easier on the system, and fuses, but few do that. When in doubt, go fast blow, and get a few. Check the manufacturer request as they know the inrush current risks to the fuse. Jallen
A quick on line search did not result in any.
Some suggest that lower amp fuse may work. For example, 8A 250V slow blow fuse may work well without affecting other components.
Any idea?
thx
How about here: (http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=F2511-ND) (http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=F2647-ND) You have no actual electronics supply houses in your area? Yes- You can always go lower in amperage safely, but then the fuse may blow prematurely too.
Thanks for the link. But one is for fast acting, and the other is (slow blow) seramic type. I want a clear glass slow blow fuse.
Well, I will keep looking. I asked the 2 ACE store and Radio Shack about electronic supply store in our area, but they had no clue. I guess I will ask around to some electronic repair folks.
What I need is 6x30mm 10A 250V slow blow fuses. So far, I found clear glass 8A 250V slow blow fuses and ceramic 10A 250V slow blow fuses.
Are ceramic tubes replaceable with clear glass tubes?

thx