2. analog
  3. 1254015115

Which wand for Morch DP-6

Greetings All
I have a Morch DP-6 with a ZYX 3 Airy sliver base.
I have been using the Red Dot wand with the cartridge.
The cartridge has worked very well in this wand except that when it plays a very deep note I get distortion. The one LP that the cartridge has never tracked properly is the very low bass note from Ray Browns LP "Soular Energy"
I sent the cartridge to Soundsmith to have it evaluated (the cartridge is over 4 year old and lots of time on it)
Peter at Soundsmith said that it is worn evenly, but is 70% worn out. He recommend that I replace the Styles only with his best diamond.

My question
Am I using the wrong wand with this cartridge?
Thanks
Bryan
bryanp
5 responses Add your response
mofimadness's avatar
mofimadness
4,933 posts
 
I was mistaken about the arm tubes as Lewm stated. It's actually a combination of the cartridge weight and the arm tube weight that gives a fundamental resonance in the 11-12Hz range.

The BLUE tube is the one that should be used. The link below has a chart of cartridges/arm tubes. Clink on Tonearm...Instructions, then click on Cartridge tonearm combination list.

Sorry for the confusion!

http://www.moerch.dk/
motnic
23 posts
 
I use a 12" blue dot arm tube with my Airy 3 SB. The general consensus is ZYX sound best with a blue arm. When I bought the ZYX I went straight for the blue arm on this advice. I have been so happy with this combination that I never felt a need to try my 9" red dot arm. (I have 12" blue and 9" red arms.)
lewm
12,456 posts
 
Mofi et al, Don't those designations for the Moerch arm wands (in grams) refer to the tonearm effective mass, rather than to the weight of the cartridge that is to be used with that particular arm wand? It makes a difference which.
thom_at_galibier_design's avatar
thom_at_galibier_design
723 posts
 
Blu-tack a nickel on the top of the headshell and re-set your tracking force. Tell us if this results in an improvement which I expect to be the case. A nickel, btw weighs right around 5 g.

Cheers,
Thom @ Galibier
mofimadness's avatar
mofimadness
4,933 posts
 
The Red Dot Morch arm tube is for a 6 gram cartridge. The ZYX 3 is a 5 gram cartridge, so you should be fine. I think it is better to be a little on the plus side, than on the lower side with the tubes. The Green tube is a 4 gram tube and the Yellow is a 8 gram tube. I would use the Red one, if it was me.

What VTF are you using? The Airy 3 recommends a 1.7 to 2.5 range. I would track at the higher end of that range.
Log in to respond
More to discover
80x80
Oracle Audio Technologies Delphi MkIV
80x80
Moerch DP8
SPECIALS
80x80
Synergistic Research PHT - Phono Transducer
- Green Dream and Black Widow