2. analog
  3. 1377558957

VTF, VTA, SRA, and 92 degrees - question

I'm familiar with the logic that has been out there for a while about setting SRA at 92 degrees for what is considered the optimal styus position, based on a lot of analysis done by Elison and others. My question is, if VTF and VTA are set per cart maker's recommendations (let's discount Anti-skate for this discussion even though it would come into play), then wouldn't the SRA be automatically set optimally per the manufacturer's intention? Assume a cart that is built to the company's design parameters - no bent cantilever, no offset stylus etc.

Take a Benz cart for example. Many (if not all) of them specify a VTA of 20 degrees. So if VTF (and yes A-S) and arm height are set so that when all's said and done the VTA is 20 degrees, isn't that what it *should* be set at based on how Benz expects that cart to perform?

I ask because I set the SRA on my Benz to 92 degrees going by that camp, and when I checked the SRA it was at - guess what - about 22 degrees. That kind of suggests Benz expects the stylus to be at 90 degrees relative to the record. Isn't that how they've designed it? Don't I run the risk of having to compensate in other ways if the cart winds up exhibiting tracking problems at an SRA that does not support the specified VTA?
tonyptony

Showing 2 responses by pbnaudio

pbnaudio's avatar
pbnaudio
1,610 posts
 
VTA and SRA are basically the same, its just a matter of where you choose to measure. A better way of putting it may be they are 100 % related to each other.

I'd state that SRA is the most accurate measurement as it is where the interface to the vinyl is. What ever VTA ends up being with a SRA at 92' is just a matter of how accurate the stylus was adhered to the cantilever.

This measurement is of course to be taken at the right VTF as varying it will change the SRA.

Good Listening

Peter
pbnaudio's avatar
pbnaudio
1,610 posts
 
I believe that the suggested 92' SRA angle is based upon that this is how most cutting lathes are set. SRA and VTA are completely aligned with each other, they change together. Again I'd state that the stylus to vinyl interface is the most important one as this is where the mechanical transfer happens.

On the other hand I don't loose sleep over the different thickness of the records I play, I set my SRA with a 180 GM record. Remember this is supposed to be fun not a chore, fretting about a different setting for each record is way beyond what I'd consider rational.

Good Listening

Peter
More to discover