2. analog
  3. 1350320370

VPI Platter Spinning SLOWLY

I've tried two different lubricants (Super Lube and Shimano Dura Ace Grease) for my VPI Classic 2 platter and it still does not spin properly. I removed and re-applied grease and it spins fine for about 5 minutes, then it slows down immensely. If I remove/re-install the platter, it spins smoothly again but only for a short period of time. Anyone experience this before and know a fix? Thanks
jyoungpark

Showing 3 responses by pbnaudio

pbnaudio's avatar
pbnaudio
1,610 posts
 
Have you cleaned out the female part of the bearing as well, grease can get stuck between the two bronze sleeves there. From your description it sounds like you have too much grease. I use Viper Lube by Locktite item # 36784

Best of luck

Peter
pbnaudio's avatar
pbnaudio
1,610 posts
 
You cannot pull out bearing just use a couple of paper towels and get out as much grease as you can from the female part, you have clearly overdone the grease. Brf is correct don't lubricate the shaft just put a dap of grease on the top of the top of the shaft at the ball bearing.

Good listening

Peter
pbnaudio's avatar
pbnaudio
1,610 posts
 
Markd51

I have a Super Platter - but it comes with a table equipped with a Maxxon DC motor controlled by a heavy duty regulator. I have an ad up for another table here on AG to give you an idea about the drive system, the one with the Super Platter has an identical drive system - shoot me an email if you are interested.

Thanks

Peter
More to discover