2. speakers
  3. 1309734559

Vandersteen 1's and Speaker Cables

Just recently inherited a set of original model 1's and am really enjoying them but have noticed a bit of top end harshness focused in the 4k area. I know it is the speakers cause that is the only change is a system that is pretty balanced. Have had good luck with Transparent and Synergistic cables in the past when trying to tame the top end but was looking for Vandi' owners recommendations of what you have tried in the past. Looking to spend less then $300 used on a set of cables...

Thanks!!
mixn4him

Showing 2 responses by audioconnection

audioconnection
1,270 posts
 
A Read the Manual for best grid placement...

B Purchase and install the sand fill able Bases available
from any Vandersteen dealer or pre owned.

C Adjust tilt back it is very important.

D After making sure you have both speakers leveled
side to side re check for proper tilt
back setting.
A washer on a string,plum bob,or laser on top of each
speaker comes in handy.
Then try some AQ Type 4 but not until all of the
above happens.
Cheers Johnnyr

audioconnection
1,270 posts
 
((Did the original Model 1's accept small spades ?))
The older 1 series took Bananas.
The Newest 1CI takes the smaller spades
like the rest of the line.
More to discover