Tube Preamp for Solid State Monoblocks?


Hi Guys/Girls of the Hi-fi World

I just acquired the Audio Zone D2 Monoblocks rated at 200wpc and of the Class D variety.

I have been hearing great things about a tube pre and solid state power amp combo and I think this would suit me well.

Any suggestions for a good tube pre (preferably under $700 used or new)?

Also, I already have a little dot MK III, would this be a good match?

Any input is greatly appreciated!
everettjsj2
I use a Modwright tubed pre-amp with my Bel Canto M300s and am very pleased. The tubed pre mates well with the Icepower amps. Synergy. I have no desire to change.
My only watchout would be impedance matching. Some of the Class D amps have a low input impedance (8-10K) and there are tube preamps with output impedances in the 1000s - those would not be good matches. Try to keep a minimum ratio of amp input impedance to preamp output impedance of 10X (that is a minimum!). Based on experience, I prefer a ratio of 40X or more.
A nice used Conrad Johnson PV-10, PV-11 or PV12 might do the trick for you. I had a PV-11 for several years with a SS power amp. Lovely combo, IMHO.
Iam also very interested in tube pre-amp. Unable to find a local dealer with a wide variety. Has any one tried Mac tube pre-amps with classe cam-400
A1, thank you very much. I have been waiting for a while to get an answer after posting the same question on other threads. This helps.
Can somebody tell me if i can use the Copland CTA402 integrated as a preamp to match it up with the monoblocks?
No, you can't.

First, it appears to not have preamp output jacks. It just has tape output (and input) jacks, which presumably are not controlled by the volume control.

Second, most or all tube integrateds (or more precisely, integrated amplifiers that have tube power stages and output transformers) should not be used as preamps, because operating the power amplifier section without a speaker load can cause damage.

Regards,
-- Al
I was looking at the same monoblocks. Can somebody tell me if i can use the Copland CTA402 integrated as a preamp to match it up with the monoblocks?
Tube pre-amps can be an excellent substitution for a ss one depending on what you expect or want to accomplish by adding one.

What about adding a tube pre-amp do you think would 'suit you well'. The reason I ask is because the answers you might receive will be influenced by your expectations as well as offers of other possibilities.
I have been hunting for a tubed pre to mate with my class D monos. In your price range I would try out the Rogue 66. You could also pick up an older Audio Research unit. If a remote is not a must have there are quite a few more options.