it's the same hex as the one to loosen VTA.
Graham Phantom - Armrest Setup
Hello,
I am installing a Graham Phantom tonearm. I cannot figure out how to loosen the armrest layer of the tonearm so that I can swing it to face the front of the table. I see two holes drilled into the armrest layer (one underneath the count weight and one on the side opposite of the VTA tower). It seems like one may need to loosen those to rotate the armrest layer, but the user manual makes no mention of using these two screws for any purpose. And it seems odd that one lies directly below the counter weight making it difficult to reach.
Right now, the armrest sits about 1/2 inch away from the outer edge of the platter. I'd like to rotate it counter clockwise to face front.
Any suggestions are welcome.
Thanks, Jeff
I am installing a Graham Phantom tonearm. I cannot figure out how to loosen the armrest layer of the tonearm so that I can swing it to face the front of the table. I see two holes drilled into the armrest layer (one underneath the count weight and one on the side opposite of the VTA tower). It seems like one may need to loosen those to rotate the armrest layer, but the user manual makes no mention of using these two screws for any purpose. And it seems odd that one lies directly below the counter weight making it difficult to reach.
Right now, the armrest sits about 1/2 inch away from the outer edge of the platter. I'd like to rotate it counter clockwise to face front.
Any suggestions are welcome.
Thanks, Jeff