Just to embellish Dopogue's initial suggestion. Getting estimates for electrical work is usually free and in the end the cost is usually less than most assume.
Keep in mind that Volts Alternating Current can have many differing issues from house to house. Unfortunately the solution to these issues can only be dealt with after your utilities meter unless you ask for an increase in service amperage which may require an upgrade of cable from the dwelling to the supply. If you have aluminum cable connected after the meter or after the dwellings main breaker it should be replaced with copper.
Tell your electrician that you'd like to have this new circuit on a different pole than lighting, refrigeration, and washer dryers or in a separate breaker box. You want a dedicated 20 amp circuit with an uninterrupted run of 10 gauge wire, preferably BX metal clad conduit to two metal receptacle boxes for a total of four Isolated Ground receptacles (8 plugs). This circuit will star ground your system.
Local code may not allow or may require the use of metal VAC components.
Again, every VAC grid is different and results of an upgrade will differ. After I had similar work done I found no substantial improvement using VAC filters or regenerators. Results will still vary.
Keep in mind that Volts Alternating Current can have many differing issues from house to house. Unfortunately the solution to these issues can only be dealt with after your utilities meter unless you ask for an increase in service amperage which may require an upgrade of cable from the dwelling to the supply. If you have aluminum cable connected after the meter or after the dwellings main breaker it should be replaced with copper.
Tell your electrician that you'd like to have this new circuit on a different pole than lighting, refrigeration, and washer dryers or in a separate breaker box. You want a dedicated 20 amp circuit with an uninterrupted run of 10 gauge wire, preferably BX metal clad conduit to two metal receptacle boxes for a total of four Isolated Ground receptacles (8 plugs). This circuit will star ground your system.
Local code may not allow or may require the use of metal VAC components.
Again, every VAC grid is different and results of an upgrade will differ. After I had similar work done I found no substantial improvement using VAC filters or regenerators. Results will still vary.