Pre-amp for Rowland Model 102


I'm looking to match a pre-amp to my JRDG Model 102 class D amp. I figure the Capri would be a good match since it also has a switched mode power supply, but, how well would a Klyne or Ayre K5xe match? Thanks.
feds
Fed, I have had extensive experience with Rowland Capri. It bested my ARC REF 3 in harmonic development, control of treble intermodulation in complex passages (think of multipart violins), bass control, and general authority and transients. Staging and imaging were comparable between the two devices. The only aspect of Capri that I thought might have benefitted from improvement was the lowest octave in the bass that could sound slightly blanched compared to REF3.

Note that a new Capri will take approximately 700 hours of operation before stabilizing and giving you its best. Like M102, it is perfectly safe to leave it on all the time, because power consumption is negligible, in spite of it operating in class-A.

You can significantly enhance the performance of your M102 by powering it through a Rowland PC-1 rectifier.

Technically, you can also connect PC-1 to both M-102 and Capri through a "Y" cord.... But I do not recommend it. PC-1 is great for M-102, M-201, M-501, and COntinuum 250, but makes the sound of Capri slightly pinched and throaty.

There is a significant amount of information on all these devices, and how they interact, on the Rowland knowledge base:

All manuals, including Capri and M102:
http://jeffrowlandgroup.com/kb/categories.php?categoryid=14

Capri FAQ (25 articles):
http://jeffrowlandgroup.com/kb/categories.php?categoryid=8

M102 FAQ (25 articles:
http://jeffrowlandgroup.com/kb/categories.php?categoryid=7

PC-1 FAQ :
http://jeffrowlandgroup.com/kb/categories.php?categoryid=23

Best, Guido

Feds, Syntax's Klyne reco is excellent, by far the best SS preamp that I have ever heard. You have noted the scarcity of them on the used market, there is a good reason for that, they are worth keeping. Keep looking, it could be very rewarding.
I'm using Power Factor correcting conditioner Furman Elite 20 PFi with Rowland 102. It does not affect dynamics but makes everything cleaner. The strange thing is that bass became cleaner - more even and musical. Very good non-sacrificial over/under voltage protection is another benefit. I don't have to worry about leaving it ON 24/7. 102 is plugged into high current outlets while Benchmark DAC1, I use as pre, is plugged into lower current preamp dedicated outlets.
Hi Kijanki, fascinating info. I did not know that Furman was producing a PFC-based conditioner. how has the Furman Elite afected harmonic detail, microdynamics, and mid-treble intermodulation? Can you isolate the separate impact on M102 and Capri? Guido
Guido, I don't have Capri. Furman made it cleaner. They claim large peak current available (large capacitor behind large inductor) but it did not improve dynamics (other than removing bass resonances). Furman made big difference on my previous digital (DLP) TV, making colors more clean and saturated. I know it doesn't sound plausible in digital domain but removing jitter can do it. One thing that made huge difference was speaker cable (Acoustic Zen Satori) that enhanced lower midrange (Cello, male voice chestiness etc.) where 102 seemed to be a little thin. In addition it has this "silky" quality (but I'm rather new to high end cables).