Class A to XX Watts

Class A biasing is beneficial when it comes to sound quality, but there are many, many other things that it affects, most notably reliability: constant thermal cycling leads to failures. Biasing is a thin veneer spec that has just a fraction to do with the overall sound and character of an amplifier - it's a detail, not a foundation.

My Boulder 1060 operates up to 17 watts in Class A before switching to Class AB, however Boulder spent a lot of time perfecting the circuit design & notching out crossover distortion. The Rowland 625 for example runs in Class A up to a higher power output level, although in reality this means very little - the biasing scheme used to keep an amplifier in a particular mode of operation can't make up for for an overall amplifier design that's not of the same calibre and may actually be necessary to compensate for non-linearities in operation. In other words, if you start out with a much better circuit design to begin with, you don't need to over-compensate with higher biasing.

Over the years of owning various classes of amplifiers I have come to realize that excellence in amplifier power supply design is far more important than cross over distortion.

It all depends on the amp design. Typical class AB amp will suffer slightly more distortions with higher bias (overbias) as it is shown here:

http://bgaudioclub.org/uploads/docs/AudioAmplifiers.pdf (chart on page 189)

and here:

http://www.kelm.ftn.uns.ac.rs/literatura/mi/pdf/AudioPowerAmplifierDesignHandbook.pdf page 107-108.

The reason for that is transonductance/gain increase (gm-doubling) when both transistors operate (class A) versus one transistor only (class B). Increasing this area of double gain slightly increases distortions. It is perhaps possible to compensate gain with signal level but it would require special design.

Another problem is that class AB amps use deeper than class A (often 10x) negative feedback to correct transistors nonlinearities. You just cannot simply overbias class AB amp and expect miracles. It is not sound quality vs. power dissipation tradeoff - it is much more complicated.

As the posters above wisely point out; there is more to making good sounding amplifiers than just Class of operation.