TRL Dude or Joule 150 MKII for Major Pre Upgrade


Thinking of either of these for what I view as a huge pre upgrade in my system. Current system is:

-Celestion A3
-Krell KAV250a (500 wpc/4 ohms).
-Nohr CD-1
-Rotel 995 preamp

I am looking to pickup warmth, depth and much more soundstage. Quality bass is also important to me. I want to keep the Celestions and feel that my current pre is the weakest link. Will also will update my digital source and ss amp down the road.

My thinking is that it will be worth paying up a bit for a higher quality pre that I can grow into.

Also I have a small naive question...with either of these pre amps will the sound difference be that great compared to the Rotel.

Thanks...any comments are appreciated.

-Iggy
iggy7
Thanks to everyone for the comments. Learning some things here (e.g. impedance, gain and availability of 6350 tubes). Know that I really cannot go wrong either way, and that either of these will possibly reduce the upgrade incentive forever. Especially, coming from the Rotel, w/ to me good value for the money.

Will say that the TRL Dude has a huge "what if", romantic factor. This is because of the type of feedback from those who have heard other, significant, high end preamps. Wish there was a review in Stereophile or Absolute Sound....etc. But of course, that would not be the last word by any means.

Regards,

Iggy
The Dude is not the issue at all. I have tried three preamps in the system and one of them was a passive. As soon as ANY of these 3 pre's are hooked up by ic's only - the buzz starts. Just an FYI. The preamps don't even have to be plugged into the wall.

My issue has nothing to do with the Dude. I seem to have a strange room or total system issue. The system was dead quiet with every other amp I have used with the same Dude as well as my last set of active ESL speakers. Please understand this is not a preamp issue. The Dude is properly ground and built to the highest standards and like a tank.

Thanks to all for the help thus far.
Well the amp seems to be the issue after more testing. I tried using Blue Jean cables that are well shielded, but the buzz continues. Again, with the preamp off and unplugged the buzz continues.

I measured as Ralph stated and could not get any reading on my ohm meter (too low) when testing for ground on the RCA 's and the middle (ground) on the AC inlet of the amp. My meter measured too low to read on the (m)ohm setting.

I tried shorting out all 4 xlr inputs between pin 1 & 3 and still have the buzz. This Buzz was not there when my previous Soundlab speakers were in the system. The buzz came for the first time when I replaced the Soundlabs with a passive speaker.

I am at a loss. I spoke with Aesthetex and they had no answers. I will try them again now, but they also seem stumped.
I meant to say I measured no ohms. I assume getting no ohms means there's no connection from the signal ground as measured at the RCA socket to chassis. Same with the power cable ground to chassis. The chassis has no resistive connection and seems isolated from everything.

This does not seem good to me.