Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
I hid my unit under my bed and my wife stepped on it and sliced up her toes very bad...

I am not going to ask because I don't even want to know.
Photonman, good news that you prefer the Teradac, am I reading right that you think it's a little better than the wall wart you have, if so in what way? And do you know if your wall wart was linear or switch mode?

As for Nelson Pass and that buffer. Many thanks to him as he first developed it for the Lightspeed Attenuator back in 2008 so that it could then drive some of his amps that had low input impedance that customers owned who wanted to use the Lightspeed with it. Those amps for memory had around 10 or 20kohm input impedance.

Here is the link to the 2008 post and circuit diagram for the Lightspeed he developed.

http://www.diyaudio.com/forums/analog-line-level/80194-lightspeed-attenuator-new-passive-preamp-137.html#post1521766

http://www.diyaudio.com/forums/attachments/analog-line-level/109114d1211904694-lightspeed-attenuator-new-passive-preamp-atten-sch.jpg

Cheers George
No its NOT, Same as a Ford Cortina is not the best car ever.
feeding a pair of shunt and series LDR's from a fixed voltage then into a potentiometer with all the consequences of ridiculously low current and some trimpots at the other end when the pot swings to maximum. I have nothing against Cortina's mum and dad drove one
And DBX was the best there was in the 80's,until you bought one and couldn't stand to listen to the music any morebecause of all the pumping noise issues.

If you try an LSA in a system that is devoid of shapeshifting devices and listen to a high resolution system, you'd understand what all the folks who own one are talking about.

It is as far away from processed sound as the Cortina is to a Bugatti.

I'm quite sure your folks were proud of that Cortina and where it took them,and for them it was the best car in the world.

Strictly speaking I would agree that the LSA is not the "best preamp ever".

It's not a Pre-Amp.

It's a volume control.
Hi Lacee
Its in the detail you miss out, DBX type 1 (not type 2) is very relevant today, works wonderfully with CD sources.

Quite correct on the description, however the post question is also wrong then.

There is far more to the NSL32SR2s and feeding it DC sadly this little car you perceive so much faith and interest in is parked and frozen in design , step across to the next garage, otherwise you will never find out.