Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
What is your concern? You have very high gain speakers and very high sensitivity amp and are concerned that you cannot get the volume low, in fact to high for background music? What gear do you have that gives rise to you concern? With my 89db Merlin's, and .8v RM10 amps there was no problem at all, though you can not make it absolutely silent, if you need to do that, I don't think you can use an LDR..
Concern is same is Gooddomino's issue. Highly sensitive speakers with an amp that has a lot of gain and/or also sensitive resulting in not enough attenuation.

So which is better Pubul57...your EMIA autoformer or this Lightspeed?
Sorry Pubul57...just went back and read your opening comment. You do indeed believe it is the best you have heard. That is quite a compliment given the equipment you have.
I sold the LSA and just got the Emia a few days ago 9 can't imagine many have been sold yet) (currrently $1,250) because I felt the need for balance controls (room, ears, recordings). After sometime assessing the Emia, I will also be getting the LSA with dual volume controls to compare A/B as I did not have both at the same time - though without "steps" might be a PIA making adjustments. To some extent, Clio9 has already made the comparison between Emia and LSA as he owns a passive based on the Slagle Slagelformer AVC, which is essentially identical to the Emia, though Emia makes "artful" cases. Clio9 seems to love both with a slight preference to the LSA, which might very well be system dependent (he wrote a "review" comparing them on Agon).

Obviously the AVC is more"impedance flexible" than the LSA, but the LSA purer, and considerably cheaper. Whatever the case, from the time I have had with the Emia, and Clio9 with the LSA, they are both wonderful passives, and if passives can work for you, both worth considering, the LSA being the obvious bargain financially, and in the right system, perhaps sonically too, as there is simply less there interfering with the signal than with an auto former, but you signal may need "conditioning" to work optimally depending on your system.

I think Clio9 has heard more passives than any person in the western hemisphere, and LSA seems to be his preferred option as this time, but there are other options that might be better suited to certain system requirments. In my system the LSA was unimpeachable sonically - at least for my taste.

If you need absolute attenuation, the LSA may not work, how sensitive are your speakers, what is the voltage of your source[s] and sensitivity of you amp? George or Clio9 might be able to give you and idea of how much of an issue it might be for you - in my case it was a non-factor.