2. speakers
  3. 1100097602

Need Inexpensive Crossover

I'm using Monitor Audio GR-10 bookselves and a Klipsch powered subwoofer. Right now I'm running them both full range - and using the low pass on the crossover to have it kick in at about 80hz.

What I want to do is to roll off the low end on the bookshelves - as the bass sounds a bit too muddy at higher volumes (and just send the higher frequencies to the bookshelves - say above 80hz)...... and then just send the low frequencies (that aren't being sent to the bookshelves) to the sub (and probably not use the subs lowpass filter at all).

I know that crossovers can get to be pretty pricey, as all high end audio can. However, right now I'm a bit tapped out on the high end audio budget... and need something that will do for the moment - maybe I can upgrade lower.

Do I need something that has both a lowpass (for the sub) filter and a highpass (for the bookshelves) filter. Can one crossover unit combine this, or do I need 2?

I'm looking at spending no more than $100.

Is this possible?

thanks for the help (in advance)
zenguy
eldartford
4,262 posts
 
Go to www.partsexpress.com. Item # 266-272. This is a passive low level high pass filter, 12 dB/octive 70 Hz. Including shipping it will cost you about $60 for two.

A better solution would be to spend more than $100, and get a real crossover. I suggest Marchand Electronics. They make several models, and if you can build a kit they are inexpensive.
thinkat
63 posts
 
check hsureseach.com . I believe they have an inexpensive high pass filter.
myraj
351 posts
 
Get a used Paradigm X-30 Crossover. It'll do exactly what you want to do. I've had one before and speak from personal experience.
New is $175 and used runs $100-$125.
Good luck!
jb0194
476 posts
 
Consider the Behringer DCX2496 (XLR in/outs, but RCA/XLR adapters are easily had).

Active crossover and digital EQ functions.

Under $400 new.

I have found it transparent in a $15K system. It's EQ function has tamed a huge (+15dB w/Rat Shack analog sound meter) 50Hz room node at my listening position. Given that competing products cost 10x or so more, it's a steal.

In many cases allowing your monitors to roll off naturally at the low end when augmenting the bottom octave with sub(s) will give better results, particularly midbass imaging and especially at low/moderate volumes. The Rat Shack sound meter (admittedly imperfect)plus your ears will allow you to use the Behringer to blend your sub in a more controlled fashion, possibly allowing a sub low pass cutoff well below the 80Hz, where the sub will actually be handling things like the bass notes of male vocals (yech).
sogood51
2,157 posts
 
The Paradigm X-30 used for around $100 is about as cheap as it gets...I have one. Not the best but well worth the money and will do what you want. For a little more the Outlaw ICBM used is even better. NHT also makes a low priced X-over.

Dave
More to discover