2. analog
  3. 1081526433

Is your turntable spinning while you clamp down?

I just got back into vinyl and I bought an inexpensive KAB clamp. So far, so good, but putting and removing the clamp can be a pain. What is the proper method? Do I turn off the turntable, change the clamp, or is it ok to clamp down and partially stop the turntable from spinning while I do this? My turntable is belt driven and I am wondering what clamping while the turntable is spinning will do to the motor and/or the belt. Is it my clamp? Can someone help an analog newbie?
matchstikman
the_smokester
174 posts
 
Based on experience, it is safer with respect to the LP, to turn the tt off while mounting the LP and clamping it. If you slip slightly the spinning platter can push the LP into the tone arm or out of your hands onto the stand or floor. Happens rarely, but turning the tt reduces the consequences of the slip.
yourmama
21 posts
 
I don't know which turntable you have, but in general turning the motor on and off just can't be good for it. Why don't you replace the clamp with a stabilizer weight and save yourself the hassle. You can easily lift the stabilizer while your tt's spinning.

Mama
jphii
485 posts
 
I do it both ways. Sometimes while it's on & sometimes whan it's off. Does not seem to have any effect whatsoever on the Teres motor.
hodie
32 posts
 
My table's maker(sounds a little center-holier-than-thou)encouraged me to leave the platter turning while I changed records. I've been doing it for 17 years with no problems.
rwd
695 posts
 
Hodie..what table do you have? I was also told that from Harry at VPI.....although I stop and unscrew.
More to discover