ANTI-CABLES by Paul Speltz: Anyone Using Them?

I just picked up a set of the Speltz IC's. Compared them to a DIY set of Jon Risch 89259/89248 twisted pair (unshielded). They didn't come close in the mids and top end.

However, I am using them to feed signal to my bass amp, which was too loud for my tube amp in a bi-amping situation. The Speltz cables muted it down a bit making the balance better. I'm using it this way until I can build a passive volume attenuator to better control the balance.

Does this really sound like a good, transparent cable to you? Me neither.

Bob

[email protected], when you unbraided them, how closely were the two wires spaced?

Silver will most likely not make them better.

I'm using the Anti-Cables bi-wired with an Ayre V1xe, and Vandersteen 5A's. There are 4 wires each side from the amp to the speakers. They are not twisted and as far from each other as possible. The sound is stunning.

Paul will braid these for you for a sight fee. I found that straight is better