I am at the end of my rope, please help


I have a problem that I can not solve and makes no sense to me at all.
My right channel is stronger than my left by a large margin. I can plug my tonearm cable directly into a Fozgometer (measures left and right output) and I get a substantially stronger signal on the right side. I confirmed this with my Voltmeter to make sure there was not a problem with the Fozgometer. So, as far as I can tell, this narrows the problem down to the Cart, Tonearm, Tonearm wire or the table.

Here is what I have tried:
1. Changed Azimuth in both directions. Small change but still much stronger on the right side.
2. Changed antiskating. Very little change.
3. replaced the cartridge. No Change.
4. replaced the tonearm and cartridge. No Change.
5. replaced the tonearm, cartridge and tonearm wire. No change.
6. I have used a second test record. No Change
My turntable is perfectly level.
I simply do not see how this is possible! I have an $83,000 system that I can not listen to. Any ideas would be much appreciated.

My system:
DaVinci Turntable > Lyra Titan i > Schroeder Reference tonearm > Manley Steelhead > Stealth Indra cables > VTL 450 amps > Stealth Mlt speaker cables > Vienna acoustic Mahler speakers
audioraider
Thanks, Hifihvn. If I understood one of Audioraider's earlier posts correctly, he already tried swapping channels at the cartridge, and the problem DID move to the other channel.

One further note to Audioraider: If you measured continuity using a yes/no "continuity" function the meter may provide, that for example simply indicates the presence or absence of "continuity" via a buzzer or some other comparable mechanism (as opposed to measuring the specific resistance quantitatively), then the detection of "continuity" with the LOMC connected would definitely have been expectable, and not indicative of anything abnormal. That kind of meter function will indicate "continuity" even when a considerable number of ohms are present.

Regards,
-- Al
Almarg,I understand that.Would a Fluke be safe for a LOMC.I never had to measure one.I use a model 179 or 85 for good stuff.
If this is correct,it is low ohms for the Lyra Titen.If I have the correct one.[http://www.audioasylum.com/cgi/t.mpl?f=vinyl&m=940292]