Balanced cable end at which end?

Thanks for the reply.Please excuse my ignorance but I meant "balanced" in the sense that one end of the RCA interconnect is grounded at one end for the shield as well as the signal.The manufacturer recommends putting the fully "earthed" end at the source.I had seen that for analogue playback using a phono stage,placing this end at the phono stage end was the way to go for the best shielding of components.I wondered if it also applied in my case as I only use the preamp for analogue playback.

OK, I understand now. Yes, the same principles would apply regardless of what components the cable is connecting. The end of the cable that is "fully earthed" should be connected to the OUTPUT of the component that is driving the cable (in this case the preamp), and the other end (the one that is not "fully earthed") should be connected to the INPUT of the component into which the signal is going (in this case the power amp). That will result in best noise performance.

Best regards,
-- Al

That's why there are arrows showing direction on cables....one end - the terminating end is grounded.