2. analog
  3. 1247951609

Tube sound Comes, mainly, from? Pre or Power?

I quite like the tube sound and I have become accustomed to it since I was a little kid. So in my own pursuit of the tube sound I have come up with a hypothesis, and I am not sure if it is in fact correct. The way I see it, the phono section and the preamp section pull about a 50-100 multiple the of the amplification done by the power section. Would it be reasonable to assume that the majority of the tube sound would come from the pieces of equipment that do the most amplification (phono and line pre), in terms of multiples? If so this would explain a popular tube pre, solid power combinations that many people utilize. Let me know what you think. I am very curious. Thanks, and please keep in mind that despite the fact that I have been listening to tubed equipment since I was born, I know very little about it and I am in the process of building up my first system.
dfelkai
Post removed 
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
I agree with everything Tvad said, including his concluding statement indicating that there are lots of differing opinions as to tube preamp + solid state power amp vs. solid state preamp + tube power amp.

I'll add that I have never encountered, and I can't envision, any particular reason why there should be a correlation with voltage amplification, assuming everything is high quality (e.g., the phono stage has low noise levels). And keep in mind that it is the power amp which provides vastly greater amplification, if defined in terms of either current or power.

Interesting and thoughtful question, though.

Regards,
-- Al
dfelkai OP
89 posts
 
makes sense. do you mind elaborating? In light of your explanation what then is the rational behind tube pre + Solid power?
swampwalker's avatar
swampwalker
5,138 posts
 
Part of the rational is ease of implementation. A tube pre-amp does not need to be biased (there probably is an exception somewhere), the tubes usually last a lot longer and are less expensive (for current production), esp on a cost/hr basis. Tube power amps may require biasing (unless auto-bias), power tubes typically more frequent changing and generate more heat. There are exceptions to pretty much all of this, but in general a tube pre-amp is pretty much plug and play, as is a ss power amp.
More to discover