2. analog
  3. 1234796174

Phono cables

OK, I am vinyl newbie so this is probably a very dumb question. First of all I am in the process of putting a vinyl system together. My current system is completely digital with a Wadia CD player directly driving the amplifier (Rowland 302).

I have just purchased a Synergy IIi on Audiogon and I'm patiently trying to locate a Rowland Cadence phonostage. One I have the Rowland stuff, then I am buying a VPI table with JMW 10.5i tonearm and Dynavector cartridge.

My question is are phono cables that connect the turntable and tonearm to the phono preamp different that regular interconnects? I am currently using Cardas Golden Reference cables in my system and looking on the Cardas website they have phono cables that have single ended with ground on one end of the cable and some unusual single connection on the other. Rowland Cadence has only XLR input and outputs. Can someone please explain the differences in phono cables and what I may need if I'm every lucky enough to find a Rowland Cadence?

Thanks in advance for any info.

Phil
philb7777
Ag insider logo xs@2x
uru975
684 posts
 
The object on the other end is called a DIN connector.
You can probably get Cardas to put both a DIN and XLR connectors on a phono cable for you.
Yes phono cables are a bit more speciallized in my experience. They are expected to pickup accurately .2mV or so volts up to say 5mV which is considerably less than most interconnects deal with.
Have Cardas in part of my system, but for what it's worth, you might check out Hovland's MusicGroove2 phono cable. If you go to the Cablecompany,com you can check out one of their's or other phono cables from their rotating lending library. A really good source to precheck some cables of any type,.
stanwal's avatar
stanwal
3,147 posts
 
The actual wiring is the same. Most arms use a special plug that fits into the bottom of the arm. However, you do not have to worry about that if you buy the VPI as they use a junction box that takes RCAs and let you use your regular interconnects. They have a balanced junction box available as an option at extra cost so you can use balanced interconnects between the table and phono stage. The arm itself is connected directly to the junction box by a cable supplied by them. You might also consider getting the Aries Extended table with the 12.7 arm, I just found out it is still available.
stanwal's avatar
stanwal
3,147 posts
 
Balanced cables of course uses XLRs, I should have said that.
almarg's avatar
Ag insider logo xs@2x
almarg
9,670 posts
 
I'm not sure if Dynavector makes any moving magnet cartridges, but if the one you are contemplating is a moving magnet type you need to take the cable capacitance into account (as well as the input capacitance of the phono stage), and make sure that the total capacitance is within the range recommended in the cartridge specifications.

If it is a moving coil cartridge, load capacitance is non-critical. Load resistance is important, but that is provided by the phono stage and is essentially not affected by the cable.

Regards,
-- Al
More to discover