2. analog
  3. 1231294811

Overhang for Ortofon 2M Bronze on Rega RB301

I just purchased an Ortofon 2M Bronze cartridge and am a bit puzzled about the overhang setting. The people I purchased the cartridge from said they set the cartridge so the front of the cartridge is flush with the front of the headshell. When I checked this with the Rega cartridge alignment protractor it shows the cartridge should be roughly 2 millimeters further back in the headshell. I listened both ways and thought the setting where the front of the cartridge was flush with the front of the headshell sounded the best. The other thing I was wondering about was the tracking force; Ortofon advised from 1.4 to 1.7 grams. I initially tried it at 1.5 grams and then 1.7 grams (as recommended by the people I bought the cartridge from). Surprisingly I like it at 1.4 grams. Any thoughts would be appreciated.
bobgates
bobgates OP
535 posts
 
Ekobesky - I use that dot on the top of the 2M Bronze as point of reference also. I have the dot just back from the center hole on top of the headshell so only half the dot shows.
musicfile
341 posts
 
Bob
How is the Ortofon Bronze sounding now that it's broken some more .. any changes to report?
bobgates OP
535 posts
 
Musicfile - it is sounding superb. Down the road I may eventually go with the 2M Black stylus.
ekobesky
259 posts
 
01-29-09: Bobgates
Ekobesky - I use that dot on the top of the 2M Bronze as point of reference also. I have the dot just back from the center hole on top of the headshell so only half the dot shows.

That sounds a little far forward to me. In my headshell, it's dead center. I align to the cantilever using a B-L two-point template. What are you using?
bobgates OP
535 posts
 
Ekobesky - I'm using the Rega cartridge alignment protractor that came with the P3-24 but I have also downloaded the Rega Stevenson ARC protractor off vinylengine.com and seem to get the same results.
More to discover