What loading do you use on your Dynavector XX2MKII

Hi Lewm,
For speakers I'm using Dynaudio Contour 5.4's. I don't honestly know if this makes a difference, but I am using a passive pre, a Sonic Euphoria, that may have something to do with my loading preference. Music sounds more of a neutral frequency balance at 10ohms. When set higher, it reminds me of old receivers with the loudness contour on, not balanced, or neutral. I am enjoying the way vinyl sounds right now more than at any time in my 40+ years in this hobby. It works for me.

Thanks,
Dan

Dan,
I too have the XX2 Mk II and have the loading set at 40 Ohms. Ralph Karsten (Atamasphere) provided a technical method of determining the loading using a function generator and an oscilloscope, and I found that with the loading set below 30 ohms, the signal began to be attenuated. Do you experience a drop in volume at that level?
Regards,
Mike

Hi Mcdonald43,

I have not noticed a drop in gain, just a more neutral frequency balance.
Regards,
Dan

Recently added 47ohm DIY resistors (thanks, Tvad!), and cartridge loading is now perfect. Once again, thanks to members for giving a helping hand when one is needed. Sure adds to the enjoyment of this great hobby!

Regards to all, and Happy New Year!

The correct loading makes an amazing difference, doesn't it? FWIW your loading is almost exactly what I measured using Atmasphere's method.
Enjoy!
Mike