Audioquest pt-6 tonearm?


I am looking to upgrade from this arm the "Audioquest pt-6" in the near future. I was just wondering what arm would fit right into it's receptacle, without me having to do any drilling or arm board change? You know just a drop in arm using the same hole without any fuss. Thank you all for any response to this question.
PS using an Vpi Hw-19 TT.
schipo
No problems with the pt-6 arm, working fine. I would just like the idea of trying a diffrent arm without the hassel of any drilling or arm board change.
write 4yanx he has used this arm on a DIY table(Lenco) and might know. Hope he doesn't mind me volunteering him like this.:)-~
You might want to add heavyweight counterweight. It improves the image focus. Yes, I do have one for sale, in case you are interested. I don't need it anymore because I have upgraded to JMW arm.
I had a PT6 for some time. Change out the cable before you go anywhere else. That makes a big difference, for sure.

I recently upgraded for a Moerch DP6. Phew - no comparison there in performance. Amazing arem, that Moerch, but I did have some mounting issues to contend with.

The PT6 has a rather large mounting hole ... the DP6 (I must like the #6) rather small. I had to route out a flange in the plinth, top and bottom, then use 2 steel washers to mount the Moerch. This gave me a little play in the overhang distance, which is quite similar to the AQ, give or take a few MM. The Moerch PT4 has the same mount as the DP6, I believe.

I was unable to find another higher quality arm that was closer to the mounting distance than the Moerch. Perhaps the Hadcock, but then there would have been cartridge compliance issues to contend with (as there are with all unipivots).

Good luck,
Bob