The balanced output from the Freya+ is plugged into a Marchand XM44-1FB Electronic crossover, 1-way, fully internally balanced. The Marchand XM44-1FB connects to 2 Schiit Tyr monoblocks. The single ended output from the Freya+ plugs into a Rhythmik FS-12E with a built in 80hz low-pass crossover at 12dB/oct.
Schiit Freya+ Tube Stage is Silent
I have a Freya+ and replaced my passive balanced crossover with an active one, reducing resistance significantly. I noticed two changes:
The SE output to my sub voltage dropped considerably (expected and addressed by moving to differential buffer mode and turning up the gain on the sub).
The gain stage for the tubes stopped output completely. Any idea why? I can give you additional history, if it is relevant. Please ignore it if it isn’t.
When I had the passive Marchand 80Hz LZ high-pass between the Freya+ and the Tyrs over balanced connections, I had too much resistance and had to take my DAC out of Unity mode (3.7V) and manually drove it to nearly 6.5V to get the volume up to drive the Maggies. The sound was awful and when in tube mode; it sounded distorted. Therefore, I bought the active crossover and reset the DAC back to Unity mode. The sounds coming from my Magnepan 3.7is are now magical and while the bass is adjusted upward for changes in output voltages, I’m disappointed the gain stage stopped working. Thinking I potentially overdrove them with the 6.5V, I ordered a replacement set of gain stage tubes. Is there a possibility I have something else going wrong in my setup?
The gain stage is a set of mid-1960s Sylvania 5687wa long black plates in VIC Audio 6SN7 to 5687 adapters. The follower stage is a set of 1947 Telefunken 12U7s diamond tips with comparable VIC adapters.
- ...
- 6 posts total
@koestner Help me understand the logic? The pass and JFET buffer stages work with the crossover in place. What about the tube would be different, other than putting out +12dB worth of voltage? |
Nothing really. I think your Marchand is fine. I was just eliminating ANY possibilities. As I said, my Freya+ had its tube section stop working while the passive and SS kept playing fine. I sent the unit to Schiit and they fixed it really quick. It was some resistor inside that blew. The repair was only $50 plus shipping. They let you know before fixing it too. I'm not making any guarantees, but what else could it be with the Freya still working in the passive and SS modes? If I understand correctly, in the tube output you're not getting any sound at all? That's what was wrong with mine. It was not distorted sound, rather no sound at all. |
- 6 posts total