JBL XPL200A The Unicorn speaker?

I had a pair of XPL200's and I loved them, clear and very fast transients. I would suggest that you keep looking for a replacement 046ti tweeter on ebay as they DO come up once in a while. The XPL140 uses the same 046ti tweeter I believe.

There's a single JBL 046Ti-S1 tweeter on ebay now, check it out!

I sold my pair because I damaged one of the 3" titanium dome midranges. Those are also very rare, but CAN be found. The 3" midranges are either model 093 or 095 but can be replaced with a modified T030 from their car speaker line by removing the internal crossover. I'm pretty sure this can be done with the tweeters from the car line as well. I will post again after doing more research. Good luck.

@joyofsound, 

JBL 046Ti-1S Tweeter Single for sale see here! 

Mike

Much appreciated but unfortunately my tweeter seems to be of the older version(?) even though it's a 200A. After fitting the 1S diaphragm, the sound was ~10db lower. Not sure if it's due to the impedance. Also, the 1S looks very different than mine. The part number I'm after is D8R046TI. Apparently it's 4ohm, which may explain the lower volume output.

Hmm, the JBL part number for a 4ohm diaphragm would be D4R046ti. What you have specified is for an 8-ohm diaphragm. Was the 1S diaphragm you installed a genuine JBL part? In a sealed JBL box? 

@joyofsound Wrote:

The part number I’m after is D8R046TI. Apparently it’s 4ohm,

It’s 8 Ohms D=diaphragm, 8R=resistance and O46TI is the driver.

JBL Technical Manual XPL200A(diaphragm replacement) see below:

file:///C:/Users/ditus/Downloads/XPL200a%20ts.pdf

Mike