Vertical Stacking Equipment

@rbschauman no bueno!

1. your phono and line stage preamps have tubes. Stacking those is highly NOT recommended. You deprive these components of proper ventilation. This means heat will shorten the life of tubes and the overall lifespan of components. If you hsbe a microphonic tube, best of luck as it will pick up and send noise to your speakers. 
2. EMI emitted by each component will creep in and cause sound degradation 

3. Phono stage will pick up EMI and RFI from other components due to extremely high proximity. This will result in hum and may probably even hear other types of distortion.
4. Tuner will compound the issues above.
 

I will be shocked if your system, after having it setup the way you want, will perform properly.
Footers will do absolutely nothing except possibly leave scratches or other types of permanent marks on covers. 
 

If I were you I would find a way to spread the components out. 

From the manuals.

To maintain proper ventilation, mount the Premier 16LS horizontally on a flat, hard surface, and take care that the ventilation holes in the bottom are unobstructed. Allow at least two inches of clearance above the unit and keep the cabinet or shelf open at the back. Vertical installation is not recommended.  

The Premier Fifteen dissipates sufficient heat that it must be adequately ventilated. Mount the unit horizontally on a flat, hard surface, and take care that the ventilation holes in the bottom are unobstructed. Allow at least two inches of clearance above the unit and keep the cabinet or shelf open at the back. Vertical installation is not recommended. 

Because the DF2 cd player dissipates very little heat, ventilation is not an important consideration, allowing greater flexibility for custom or built-in installations. Of course, reasonable judgement must be exercised to see that the DF2 does not obstruct ventilation required by amplifiers or other equipment in the system. The DF2 is designed to be mounted horizontally.

@rbschauman 

you don’t have your system listed in your profile. Can you create a virtual system and show us this cabinet or add one to a post in the thread?  If you are not able to add supports to the side walls inside the cabinet for shelves, maybe you could add supports/legs to go all the way to the bottom and then continue that pattern upward so each shelf is supported from what’s below.  

Hockey pucks.  

"you don’t have your system listed in your profile."

He does in his post above.

The pieces are:

Conrad Johnson Premier 16LS Preamp (weight 25 lbs.)

Conrad Johnson Premier 15 Phono Preamp (weight 22 lbs.)

Conrad Johnson DV 2b CD Player (weight 20 lbs.)

Magnum Dynalab MD102 Tuner (weight 16 lbs.)