I own all McIntosh equipment from Preamp to Streamer DAC that also includes a MCD550 SAD/CD Player. After buying the CS200 streamer did I have conflict with remotes. I went to my McIntosh Manuals which showed how to change the IR remote response to the individual units and or maintain contol with the individual remotes. I find it frustrating that each unit comes with a that are difficult to coordinate. Once I did those steps it was a relief of frustration of the battle of remote signaling. If you haven’t already, give it a try…
McIntosh MA 12000 Remote Changing Inputs On My MCD 12000 CD Player
The remote for my McIntosh MA 12000 Integrated amp is changing inputs on my McIntosh MCD 12000 CD/DAC. How do It make stop? I want to leave my CD player/Dac on the input of my choosing. For example, if I am watching tv and want to change the input on the Integrated amp to listen to music, it also changes the input on the CD player so then I have to cycle through the inputs to get the one I want.
- ...
- 9 posts total
@kclone comes with a different remote rhat are difficult to coordinate. |
well, I went to the manual for the MCD 12000, to use alternate code the instructions are as follows. Press and hold the SELECT button on remote then press and hold the 2 button until the two LEDs to the right of the shift button flash twice. I did that several times but couldn't get it to work. The remote for the MA 12000 integrated still controls the CD player. I then tried to go to the manual for the MA 12000 to see if I can change to an alternative remote code for that. Much more complicated. I haven't been able to figure out how to get through the steps on that yet. Very frustrating. |
- 9 posts total