Mogami Power Cable

Correction- I meant Mogami W3104 based on the following youtube video:

If you are going to build an ungrounded/unshielded cable for a unit that does not require ground, that makes sense.

I prefer to make only shielded power cables to minimize noise pickup after my power conditioners though.  This is true even when going to a device that does not require ground.  The shielding is worth it for me.

Worth noting that most power cables have a ground wire but are not foil shielded. 

As I mentioned, both of the other cables mentioned by the OP are shielded. 

In addition to what Erik said, I'll add that I don't trust this guy much.  I'd double check everything he says, especially whether a ground wire is required.  His graphics call 2 12awg wires 6 awg which is wrong (they are about 9 awg) so he lacks some understanding.  I didn't watch the rest of the video to see if he got other things wrong.

Jerry

To be clear: I’m not ever advocating the use of signal wires for power applications. Here’s my go-to shielded power cable:

Thanks so much for the responses!  I've had very good luck with Mogami speaker and rca cables in the past and was hoping for a Mogami power cable.  I will take a look at the DH Labs cables for sure.  I've heard great things about the Yarbo and Oyaide cables but the Yarbo appears to be a bit tricky to work with removing the teflon jacket from each conductor strand.  Do you have any recommendations for plugs?  Thanks again!