DAC DIRECT IN TO AMPLIFIER OR TO PREAMPLIFIER


For the longest time, I believed that the best preamplifier is no preamplifier.  Eliminating a component from the audio chain would yield less distortion & greater purity.

Recently, I have had reason to re-think my logic on the matter - and I am (I think) changing my mind.  Better said, assuming that the preamplifier in the component you are using (in my case, a DAC) can produce 95% or greater quality sound compared to the preamplifier component, then no preamplifier is the best option.  The 5% represents the (estimated) loss of fidelity in adding another set of interconnects.

That said, most DACs do not have an outstanding preamplifier built in.  I think most have average passive attenuators, and the better DACs have active preamplifiers that are very good - but not as good as a quality preamplifier.

What are your thoughts?

 

 

128x128paul_lindemann

Update:

In my case the pre-amplifier made a noticeable improvement in sound quality- more than I thought it would. The Lumin volume control was fine, but adding a preamp confirmed my suspicion that I was missing out on something. This made the difference I needed from my system. I’m satisfied with my gear now and will be focusing on room treatment moving forward. I only listened to streaming and my NAS. I haven’t rewired the turntable for XLR yet, but will in the next couple days. I can imagine that results for a preamp will depend on the preamplifier being used. This might be where the "your results may vary" and "system dependent" comments come from. There’s no going back for me. If I had to describe the difference between running direct from the Lumin S1 compared to running through the preamp: with the preamp- more depth, better separation of instruments, more full sound, and better focused center image. The only downside I’ve noticed is it does make a little hiss with volume all the way down from the speakers, but it’s minor. I’m thinking this is normal since it’s a tube preamp. It’s still less noise than my old tube amp made though. I hope you find this information helpful.

A low hiss is not normal from a good quality or better tube preamp. Deed quiet is the mark.

Low hiss, can you hear it from your seat? If not… not a problem. Even if does, does it go away at low volume? Tube stuff is never gonna be DEAD quiet IME.

On the topic of tube hiss. I have all-tube cj gear: hiss evident at idle, although not loud enough to spoil my enjoyment of music. Replace factory-supplied tubes with some NOS Westinghouse and GE pre-amp and amp input tubes (not power output - couldn't afford that) from Vintage Tube Services. System now dead quiet at idle. Based on my experience, tube equipment can be quiet - all depends on the tubes, and the equipment of course.

+1 it depends on your unique situation.  Some chains sound better with a preamp, other without. It’s not easily predictable, best to try in your own audio chain.