TT cable question

Great! Thank you!

Ya know, I wanted to call it a "spade lug", but then I started to think about spade connectors and was fearful of misleading the OP.  "Fork-like" is vivid, I thought.

+1 @lewm 

Some TT's ground through the shield on one channel, like my Thorens 165. Simply adding a ground wire might make a "loop" and introduce hum. Go to vinyl engine and down load your shop manual. TT signal voltage is much lower than line inputs, Maybe here you want to stick with TT leads, OEM or aftermarket

It is ONLY the Cartridge/Tonearm that needs to be grounded. No separate ground wire is needed from Preamp to Amp

A typical Phono Cable has an integral ground wire

Separate Ground Connectors (various types of wire attachment terminals) exist at both ends/both devices for the ground wire of the Phono Cable. Labeled GND, or something like that.

ANY ’real’ Phono input receives the cartridge’s low level un-equalized signal and a ground connection must exist, typically adjacent to the ’phono’ input (not always adjacent, it can be somewhere else on the back of the input device).

Other ’non-real’ Phono Inputs exist, but they are simply ’named’ Phono, for the convenience of front selector input names. They are ’line level’ inputs, requiring the cartridge’s low level and un-equalized signal to have been converted to line level elsewhere. No ground wire is needed for those ’non-real’ phono inputs.

Typically, if you see the rear panel, and a pair of rca jacks exist labeled phono, if there is no adjacent separate ground connector, it is a ’non-real’ ’named’ phono input.

Careful research of any device is required to determine if the device contains a ’real’ phono input of the cartridge’s low level signal or a ’non-real named’ phono input of an already equalized/boosted to line level signal strength.