If your speakers have 4 posts each, by all means bi-wire! 4 is better than two.
Bi-Wiring
Although the option to do so is there, I hadn't planned on bi-wiring my speakers, especially after watching this: https://www.youtube.com/watch?v=McH2tlfj0vo
In the video it only speaks of bi-wiring on the speaker side (and a bit about bi-amping). But my amp has two sets of binding post for each channel as shown here: https://coda.cc/coda-no-8-amplifier
I have reached out to both my dealer and the manufacturer about this with no response as of yet, so I was looking to you all for what your thoughts are on this?
Will running 2 pairs of speaker wires to the 4 individual binding post do anything for me or would the info in the video still prevail? Thanks!
- ...
- 43 posts total
It depends on speaker... My tannoys do sound very different biwired over single wire and jumpers. Previous speakers I have had from linn and quad sounded no better. Also with 4 sets of outputs on amp it depends how they are wired up. My luxman has 2 speaker outputs but they are in parallel so running 2 sets of single wire has no effect on sound. |
@richdirector - I have a Coda #8 and I'm presuming the speaker outputs are in parallel as well. |
- 43 posts total