Interconnect advice needed


Hi

I need an almost 10 feet interconnect between pre amp and power amp. Both with tubes.
I know all cables affects the signal and naturally I I want this effect to be as small as possible.
I've just bought Klipsch Heresy IV and I don't want the cable to emphase the midrange bump in these speakers even more.

Any suggestion for a cable this long max $1000?

simna

Fwiw...i dont know if stereo5 is talkin about "v twist"...have 2 pairs eti/2 pairs aeco.There are other cu models as well... "pulsar" is a killer little wire as well.

Neutral clean goodness.😋...ive stopped lookin.

Sounds like you’ve got all the answers and are just opening a debate again on the pros and cons  of cables. Respectfully, a waste of time.

Cheers 

Given what you have said I would consider DHLabs, Transparent, or WireWorld. The later two go for used. UsedCables web site. I would try to make sure they are doing whst you want. If new… remember it takes a couple hundred hours for them to break in. 
 

My system are shown under my ID so you can see where I am coming from.

10 feet is a short run for rca you shouldn’t run into any problems unless you have a lot of loose electricity flying around in the air. Xlr is great for long runs since it’s redundant and also shielded at the same time the cable carries 2 signals a forward and reverse signal so if one signal is  compromised  the sound still comes through. Have a nice journey with your audio experienceÂ