Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

Posting this for those who may be interested in utilizing Cube Audio drivers in a DIY setting. 

@realworldaudio  sometimes posts within the general forum. I find what he shares thoughtful and helpful.  He recently installed the Fc8 driver in his Voigt Pipe cabinets. He has a YouTube channel and this video covers his Fc8 driver impressions, immediately after the install.

Cube Audio Fc8 driver in Voigt Pipe speaker cabinets

@david_ten The V2s disappear better on all recordings than the V1s.  The extended bass and high frequencies result in better soundstaging and center fill.  It might be that I needed to move the V1s closer together than the V2s.

I haven't validated yet but I also think my Ayon Audio Odin SET tube based amp will better mate or bed in with the V2s.  

@mikeg   Thanks, Mike.  Also, great to hear that your Ayon SET may be the preferred pairing.

@david_ten What I mean related to the Ayon SETs is that the V2s would pair better than the V1s.  If you remember, Cube Audio didn't like the pairing of the V1s with 300B based amps which I think is closer to the SET tube used by Ayon Audio. The V2s pair extremely well with the FW SIT-1.  As it has been stated by others, the V2s will pair with more amps and that is another reason Cube Audio went in that direction.

If you remember, Cube Audio didn’t like the pairing of the V1s with 300B based amps

I was under the impression that Cube Audio specifically had lower power, high output impedance amplifiers in mind to pair with the Nenuphar characteristics. 300b/2A3/PX 25 etc were the intended targets. Thus the very damped driver via very powerful magnets/motor. Exactly why an amplifier with high damping factor is not seen as advantageous. A good quality 300b SET would seem an excellent Nenuphar partner.

Charles