Cartridges for Rega Tables

OP if you are using a Lyra Kleos on a Rega arm without VTA spacers you are wasting it.  
The Rega cartridges are 14mm from base to stylus tip.  Hana have some 16mm cartridges.  

The Hana EH, EL SH, SL are all 15 mm high so they probably would not require shims on the Rega; of course, no 3 point mounting system and keep in mind that the L models require 400+  ohm loading.

I am currently using the Kleos with 3.5mm spacers, Jonathan Carr had told me that his calculations for the Rega arm with Kleos should be 3.4mm and rather than have a shim special made I figured 1 tenth mm was close enough. 

So if Rega carts are 14mm and the Hana are 15mm then I would need a 1 mm shim, which I do have. Are the Dynavectors 14mm or at some of their offerings?

As far as the 3 point I am not concerned, I can set the alignment. But this is giving me some options to investigate. 

LOMC Dynavectors appear to be between 15.9 mm and 18.1 mm in height depending on the model.

Hana are 16mm to the tip of the stylus.  
Dynavector 17DX3 is 15.8mm and an excellent sounding cartridge.