Copland DRC205 digital room correction

What does the DRC205 retail for?

Bigcahuna2000, I have the same problem. I received my DRC205 on Saturday. During installation of the software, right before the "finalize" screen it comes up with a page stating something to the effect of USB driver not found. The Copland software installed on my laptop (windows 98) but I have no communication with the DRC205. The instruction page showed a diagram about trying different com ports but that was not successful for me either. Perhaps there is a software problem or internal problem with a certain batch. I don't know the serial number of mine without going home and looking. Of course the store I purchased it from is closed as everyone went to CES.

So far, I prefer the basic flat filter. The bass definition is much improved. It has a range of brightness through the lower treble/upper mids that I would like to alter but can't, due to the computer problem.

jla, the current retail is 2995.00.

The installation was somewhat clunky and counterintuitive. As I recall, the software needed a USB driver and some sort of serial port emulator. I was able to install the program on an older Dell XP Pro-based laptop without undue difficulty.

I am not terribly surprised that it does not work on a Windows 98 platform. Was the DRC connected when you installed the software? The manual is very emphatic on this point. It may be worth uninstalling the utility and trying again.

Wazmoh, I do believe I had the DRC connected when I installed the program but I will try the "un-install" and attempt to install it again and see what happens. The manual states it is Windows 98 compatable, but who knows.

Another quibble, the instructions for making the microphone measurements are severly lacking with regards to orientation. They say to position the mic at your listening position at ear level and that's it. When I first made the measurement, I had the mic facing forward and that was wrong. The mic doesn't appear to be an omni but it must be. I ran the measurement again holding the mic vertically and obtained far better results.

Wazmoh, I used a somewhat older laptop with XP Pro with the software installed. Then I connected the DRC205 and it displays a message that it cannot connect to a USB device. Here is where the computer is supposed to show "New Hardware connected to...." and then you can load the drivers for the USB to Serial conversion drivers. But when I point it to the CD drive to the "i386" directory for the "drivers" it displays that there is no appropriate files for the system to install. I believe the computer is looking for an *****.inf type file to load the drivers with, but there is no ****.inf designated file on that whole installation CD. This is extremely frustrating because I purchased the unit from Divertech since I did not know of any distributors in the U.S. at the time. They are of absolutely no help, and Copland has no email addresses listed on their website. I also tried using the latest drivers from FTDI.com but they do not work either. Thank you for any help you can think of.